Hallo Leute,
leider kann ich euch nicht sagen wie genau man den T1 flashed. Aber ich schätze es würde einige interessieren und eine genaue Anleitung findet man auch nicht so recht..
Viele meinen man muss den GPIO mit 0V(GRD) verbinden um in den Flash Mode zu kommen, allerdings nennt das Wiki eine einfachere Methode.
Kann jemand, der bereits einen T1 2CH geflashed hat, sich kurz die Zeit nehmen um eine Schritt für Schritt Anleitung zu schreiben?
Zitat:
"To enter flashing mode the unit should be powered and connected to the programmer of choice. Touch Button 1 should then be held while the reset button (4) is pressed. This will cause the unit to reboot into flash mode. This is confirmed on a serial console (74880 baud) by the boot mode displaying (1,x) indicating that we are booted to the bootloader and not the flash. Button 1 can then be released. You can also confirm booted to flash without a serial console, the main led should be off and the backlight LEDs lit dimly. There is no longer a need to solder anything to GPIO0 or to ground it while powering up, like previously believed. This step is replaced by the above button sequence."
Danke euch!